Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Digital System Projects Using HDL
In the keypad HDL encoder, after releasing a key the ring counter resumes its counting sequence.
True
Correct Answer:
True
← Previous Question
Next Question→
More Questions from
Digital System Projects Using HDL
In the frequency counter, a pulse shaper block is needed to ensure that the unknown signal, whose frequency is to be measured, will be compatible with the clock input for the counter block.
The frequency counter measures frequency by enabling a counter to count the number of pulses of the incoming waveform during a precisely specified period of time called the sampling time.
The full-step sequence always has two coils of the stepper motor energized in any state of the sequence and typically causes 30° of shaft rotation per step.
In the digital clock project, the AHDL block codes are connected using graphic design files.
One of the first steps in any HDL project is to define its scope by knowing the nature of all the signals that are interconnected to pieces of the project.
In the keypad HDL encoder, the data signal is used to combine the row and column encoder data to make a 4-bit value representing the key that was pressed.
In the VHDL code of the stepper motor, the cout outputs are bit_vector type because they are binary bit patterns.
In HDL, one of the strategies used in strategic planning is to find the speed requirements.
In the digital clock project, frequency prescaling is used to take a 1 pps input and transform it into a 60 pps timing signal.
The direct drive mode of a stepper motor allows for less control by the operator.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments