Home » Civil Engineering » UPSC Civil Service Exam Questions

The side AD of the square block ABCD as shown in the given figure is fixed at the base and it is under a state of simple shear causing shear stress τ and shear strain π, where The distorted shape is AB'C'D. The diagonal strain (linear) will be

Correct Answer:

← Previous Question Next Question→

More Questions from UPSC Civil Service Exam Questions

For designing end bearing piles of square cross-section in clays having average unconfmed compressive strength of 6 t/m2, the net ultimate bearing capacity may be taken as
A plot of land 60°m x 20 m is measure steel tape. If the standard error of length width measurements is taken as ± 1 cm, the standard error of the area of the plot be
A short column of external diameter D and internal diameter d, is subjected to a load W, with an eccentricity 'e', causing zero stress at an extreme fibre. Then the value of 'e' must be
Which type of light energy is effectively absorbed by CO2 in the lower boundary of the troposphere?
If the pressure carried by a CBR specimen at 2.5 mm penetration is 3.5 N/mm2, the CBR of the soil is
Purlins are provided, in industrial buildings, over roof trusses to carry dead loads, live loads and wind loads. As per IS code, what are they assumed to be?
The ratio of total elongation of a bar of uniform cross-section produced under its own weight to the elongation produced by an external load equal to the weight of the bar is
The rectangular block shown in the given figure is subjected to pure shear to intensity 'q'. If BE represents the i principal plane and the principal stresses are σ1, σ2 ; then the values of θ, σ1 and σ2 will be respectively.
According to ICAO recommendations, what is the rate of elevation correction for the runway above MSL?
Consider the following statements : Sand in mortar is needed for 1. decreasing the quantity of cement. 2. reducing shrinkage. 3. decreasing the surface area of the binding material. 4. increasing the strength. Of these statements :

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion