Curioustab

Home » Civil Engineering » Theory of Structures

The assumption in the theory of bending of beams, is :

material is homogeneous
material is isotropic
Young's modulus is same in tension as well as in compression
each layer is independent to expand or to contract
all the above.

Correct Answer: all the above.

← Previous Question Next Question→

More Questions from Theory of Structures

In case of a simply supported rectangular beam of span L and loaded with a central load W, the length of elasto-plastic zone of the plastic hinge, is
Beams composed of more than one material, rigidly connected together so as to behave as one piece, are known as
A rolled steel joist is simply supported at its ends and carries a uniformly distributed load which causes a maximum deflection of 10 mm and slope at the ends of 0.002 radian. The length of the joist will be,
Total strain energy theory for the failure of a material at elastic limit, is known
Shear strain energy theory for the failure of a material at elastic limit, is due to
For determining the support reactions at A and B of a three hinged arch, points B and C are joined and produced to intersect the load line at D and a line parallel to the load line through A at D'. Distances AD, DD' and AD' when measured were 4 cm, 3 cm and 5 cm respectively. The angle between the reactions at A and B is
A material which obeys Hook's law, is subjected to direct stress σ0. At its elastic limit, the following statement is true,
Pick up the incorrect statement from the following : The torsional resistance of a shaft is directly proportional to
The force in BF of the truss shown in given figure, is
The ratio of the deflections of the free end of a cantilever due to an isolated load at l/3rd and 2/3rd of the span, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion