Curioustab

Home » Civil Engineering » Surveying

Ranging in chain survey means

looking at an isolated point not on the line
establishing an intermediate point on the line
determining the distance between end points
determining the offset distance
none of these

Correct Answer: establishing an intermediate point on the line

← Previous Question Next Question→

More Questions from Surveying

In levelling operation,
While measuring with a metallic tape of 30 m length pull should be applied
To set out a parallel from a given inccessible point to a given line AB, the following observations and made Distance AB and angle PAM = a and angle PBA = b are measured where Mis a point on the line BA produced. The perpendicular to the desired parallel line from A and B are :
The bearing of AB is 190° and that of CB is 260° 30'. The included angle ABC, is
The ratio of the radius and apex distance of a curve deflecting through Δ°, is
Surveys which are carried out to depict mountains, rivers, water bodies, wooded areas and other cultural details, are known as
The ratio of the distances at which a stated length can be distinguished by the telescope and the human eye, respectively, is called
A lemniscate curve between the tangents will be transitional throughout if the polar deflection angle of its apex, is
The operation of revolving a plane table about its vertical axis so that all lines on the sheet become parallel to corresponding lines on the ground, is known
In a closed traverse, sum of south latitudes exceeds the sum of north latitudes and the sum of east departures exceeds the sum of west departures, then, the closing line will lie in

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion