Curioustab

Home » Civil Engineering » Surveying

The branch of surveying in which both horizontal and vertical positions of a point, are determined by making instrumental observations, is known

tacheometry
tachemetry
telemetry
all the above.

Correct Answer: all the above.

← Previous Question Next Question→

More Questions from Surveying

The latitude of a traverse leg is obtained by multiplying its length by
Probable systematic error in precise levelling as recommended by International Geodetic Association should not exceed (where k is in kilometers.)
If the rate of gain of radial acceleration is 0.3 m per sec3 and full centrifugal ratio is developed. On the curve the ratio of the length of the transition curve of same radius on road and railway, is
True meridian of different places
For setting out a simple curve, using two theodolites.
Orientation of a plane table by solving two point problem is only adopted when
Measuring with a 30 m chain, 0.01 m too short, introduces
A uniform slope was measured by the method of stepping. If the difference in level between two points is 1.8 m and the slope distance between them is 15 m, the error is approximately equal to
Keeping the instrument height as 1 m, length of staff 4 m, the up gradient of the ground 1 in 10, the sight on the up slope must be less than
For a curve of radius 100 m and normal chord 10 m, the Rankine's deflection angle, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion