Curioustab

Home » Civil Engineering » Structural Design Specifications

The anchorage value of standard U-type hook of a reinforcing bar of diameter d in tension, is

4 d
8 d
12 d
16 d
20 d

Correct Answer: 16 d

← Previous Question Next Question→

More Questions from Structural Design Specifications

The thickness of the rectangular plate for the cap or base of a solid round steel columns, is calculated from the formula where d is
The actual length of a column provided with a cap and base, is the distance between
The thickness of flat single lacing is, taken (where l is effective length of the bar).
The greater clear dimension of web of thickness't' should not exceed
For under water concreting.
Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept
In the formula
The staggered pitch is the distance between two consecutive rivets measured
A column of rectangular section is considered short, if both the slenderness ratios are less than
If a and b are the sides of a square column and its base, the thickness of the base may be calculated from the formula

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion