Curioustab

Home » Civil Engineering » Strength of Materials

For structural analysis of forces, the method refers to

moment-area-theorem
three-moment equation
Maxwell's reciprocal theorem
none of these.

Correct Answer: moment-area-theorem

← Previous Question Next Question→

More Questions from Strength of Materials

A simply supported beam of span L carries a uniformly distributed load W. The maximum bending moment M is
The property of a material by which it can be beaten or rolled into thin plates, is called
A three hinged parabolic arch hinged at the crown and springings, has a horizontal span of 4.8 m and a central rise of 1 m. It carries a uniformly distributed load of 0.75 tonne per metre over half left hand span. The horizontal thrust at the support will be
In rectangular columns (cross-section b x h), the core is a
When equal and opposite forces applied to a body, tend to elongate it, the stress so produced, is called
The reaction at support A of the beam shown in below figure, is
If a shaft is simultaneously subjected to a toque T and a bending moment M, the ratio of maximum bending stress and maximum shearing stress is
The length of a column which gives the same value of buckling load by Euler and Rankine-Gordon formula, is equal to
The length of a column, having a uniform circular cross-section of 7.5 cm diameter and whose ends are hinged, is 5 m. If the value of E for the material is 2100 tonnes/cm2, the permissible maximum crippling load will be
A bending moment may be defined as :

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion