Curioustab

Home » Civil Engineering » Steel Structure Design

In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon :

pitch
gauge
diameter of the rivet holes
all the above.

Correct Answer: all the above.

← Previous Question Next Question→

More Questions from Steel Structure Design

The stress in the wall of a thin cylinder subjected to internal pressure, is
The greatest permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to
The stiff portion of a bearing stiffener is taken equal to
If d is the distance between the flange angles of a plate girder, vertical stiffeners are provided at a distance not greater than
The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of
The strength of ISA 125 = 75 x 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is
Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
If P is the wind pressure in kg/cm2, v is the velocity in km/hour and K is a constant of proportionality, then
Efficiency of a riveted joint is defined as the ratio of
If fbt and fc are the co-existent bending tensile stress and shear stress in a member, the equivalent stress fc is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion