Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Steel Structure Design
For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is
HTW grade of thickness exceeding 32 mm
HT grade of thickness exceeding 45 mm
HT grade of thickness not exceeding 45 mm
All the above.
Correct Answer:
All the above.
← Previous Question
Next Question→
More Questions from
Steel Structure Design
To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be
The permissible stress to which a structural member can be subjected to, is known as
Diameter of a rivet hole is made larger than the diameter of the rivet by
Factor of safety is the ratio of
When the length of a tension member is too long
Bulb angles are used in
IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every
Effective sectional area of a compression member is :
A single angle in tension is connected by one leg only. If the areas of connecting and outstanding legs are respectively a and b, net effective area of the angle, is
With a percentage increase of carbon in steel, decreases its
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments