Curioustab

Home » Civil Engineering » Steel Structure Design

Rolled steel beams are :

mainly used to resist bending stress
used as independent sections to resist compressive stress
used as independent sections to resist tensile stress
All the above.

Correct Answer: All the above.

← Previous Question Next Question→

More Questions from Steel Structure Design

The effective length of a compression member of length L held in position at both ends but not restrained in direction, is
When the ratio of the moment M to axial load P is greater than, the resultant of the compressive bearing pressure which acts at a distance Y from one side, is given by
Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed
A web plate is called unstiffened if the ratio of clear depth to thickness is less than
If the thickness of a structural member is small as compared to its length and width, it is classified as
If R is the reaction on the bearing plate, the minimum moment of. inertia of the bearing stiffener provided at the support of a plate girder of overall depth D, the maximum thickness of the compression flange T, carrying total load W, is
For steel members exposed to weather and not accessible for repainting, the thickness of steel should not be less than
Long column is one
For a cantilever beam of length L continuous at the support and unrestrained against torsion at the support and free at the end, the effective length l is equal to
If N is the number of rivets in the joint, the strength of a riveted joint against shearing of rivets, is given by

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion