Curioustab

Home » Civil Engineering » Steel Structure Design

Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is

180
200
250
300
350

Correct Answer: 350

← Previous Question Next Question→

More Questions from Steel Structure Design

If P is the wind pressure in kg/cm2, v is the velocity in km/hour and K is a constant of proportionality, then
Efficiency of a riveted joint is defined as the ratio of
If fbt and fc are the co-existent bending tensile stress and shear stress in a member, the equivalent stress fc is
For simply supported beams, the maximum permitted deflection, is
A structural member subjected to tensile force in a direction parallel to its logitudinal axis, is generally known as
The size of a butt weld is specified by the effective throat thickness which in the case of incomplete penetration, is taken as
The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula
The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at
If d is the distance between the flange angles,
The beam outside a wall upto floor level above it, is known as

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion