Curioustab

Home » Civil Engineering » Steel Structure Design

The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of

the effective span
1.25 times the effective span
1.50 times the effective span
2.0 times the effective span
2.5 times the effective span.

Correct Answer: 1.25 times the effective span

← Previous Question Next Question→

More Questions from Steel Structure Design

The strength of ISA 125 = 75 x 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is
Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
If P is the wind pressure in kg/cm2, v is the velocity in km/hour and K is a constant of proportionality, then
Efficiency of a riveted joint is defined as the ratio of
If fbt and fc are the co-existent bending tensile stress and shear stress in a member, the equivalent stress fc is
For simply supported beams, the maximum permitted deflection, is
A structural member subjected to tensile force in a direction parallel to its logitudinal axis, is generally known as
The size of a butt weld is specified by the effective throat thickness which in the case of incomplete penetration, is taken as
The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula
The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion