Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Steel Structure Design
If the slenderness ratio is greater than 160, the allowable stress in axial compression is multiplied by a factor (1.2 - (l/xy) where x is
200
400
600
800
1000
Correct Answer:
800
← Previous Question
Next Question→
More Questions from
Steel Structure Design
For double angles carrying tension, placed back to back and connected to either side of the gusset plate, the sectional area of the section, is equal to cross sectional area of
A major beam in a building structure, is known as
The moment of the couple set up in a section of a beam by the logitudinal compressive and tensile force, is known as
The bending moment for filler joists at the middle of at intermediate span, is
The effective length of a compression member of length L, held in position and restrained in direction at both ends, is
The rivets which are heated and then driven in the field, are known
A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
An axial loaded column is supported on a slab base whose projection is 8 cm. If the intensity of pressure from concrete is 40 kg/cm2 and allowable bending stress in slab base is 1890 kg/cm2, the thickness (t) of the slab base, is
The most commonly used sections in lateral system to carry shear force in built up columns, are
The maximum axial load which is just sufficient to keep a column in a small deflected shape, is called
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments