Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Steel Structure Design
If d is the distance between the flange angles of a plate girder, vertical stiffeners are provided at a distance not greater than
d but not less than 0.20 d
1.25 d but not less than 0.33 d
1.5 d but not less than 0.33 d
2.0 d but not less than 0.50 d
2.5 d but not less than 0.50 d
Correct Answer:
1.25 d but not less than 0.33 d
← Previous Question
Next Question→
More Questions from
Steel Structure Design
The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of
The strength of ISA 125 = 75 x 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is
Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
If P is the wind pressure in kg/cm2, v is the velocity in km/hour and K is a constant of proportionality, then
Efficiency of a riveted joint is defined as the ratio of
If fbt and fc are the co-existent bending tensile stress and shear stress in a member, the equivalent stress fc is
For simply supported beams, the maximum permitted deflection, is
A structural member subjected to tensile force in a direction parallel to its logitudinal axis, is generally known as
The size of a butt weld is specified by the effective throat thickness which in the case of incomplete penetration, is taken as
The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments