Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Steel Structure Design
Design of a riveted joint, is based on the assumption:
Load is uniformly distributed among all the rivets
Shear stress on a rivet is uniformly distributed over its gross area
Bearing stress is uniform between the contact surfaces of the plate and the rivet
Bearing stress in the rivet is neglected
All the above.
Correct Answer:
All the above.
← Previous Question
Next Question→
More Questions from
Steel Structure Design
When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is
Pick up the correct statement from the following:
If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is
The economical depth d of a web plate in which allowable bearing stress is fb, and the maximum bending moment is M, as suggested by Rawater and Clark, is
Under a concentrated load, bearing stress fb in a beam, is given by (where b is the length of the bearing plate and h is the depth of the root of the fillet).
Tacking rivets in tension members, are provided at a pitch in line not exceeding
With usual notations of the letters, the shear stress fs at any point of the cross-section is given by
Rise of a Jack arch is kept about
For a single section used as a tension member, the given area is assumed
A column is carrying an axial load W and an eccentric load P. If A is its cross-sectional area, ex and ey are the eccentricities and Pxx and Zyy the section modulli, the equivalent axial load is obtained from the formula,
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments