Curioustab

Home » Civil Engineering » RCC Structures Design

In a singly reinforced beam, the effective depth is measured from its compression edge to

tensile edge
tensile reinforcement
neutral axis of the beam
longitudinal central axis.

Correct Answer: tensile reinforcement

← Previous Question Next Question→

More Questions from RCC Structures Design

[A + (m - 1)ASC] known as equivalent concrete area of R.C.C. is given by
Pick up the incorrect statement from the following. The intensity of horizontal shear stress at the elemental part of a beam section, is directly proportional to
A simply supported beam , 6 m long and of effective depth 50 cm, carries a uniformly distributed load 2400 kg/m including its self weight. If the lever arm factor is 0.85 and permissible tensile stress of steel is 1400 kg/cm2, the area of steel required, is
Pick up the true statement from the following:
If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is
If a rectangular prestressed beam of an effective span of 5 meters and carrying a total load 3840 kg/m, is designed by the load balancing method, the central dip of the parabolic tendon should be
If the sides of a slab simply supported on edges and spanning in two directions are equal, the maximum bending moment is multiplied by
If the permissible compressive and tensile stresses in a singly reinforced beam are 50 kg/cm2 and 1400 kg/cm2 respectively and the modular ratio is 18, the percentage area At of the steel required for an economic section, is
If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than
For stairs spanning horizontally, the minimum waist provided is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion