If V is the design speed of vehicles in km/hour, the change of radial acceleration in metres/sec3, is

More Questions from Highway Engineering

• Width of a rotary round should be equal to
• When a number of hair pin bends are introduced, a minimum intervening distance in between is kept
• The statement, regarding the size of stones used at the wearing surface. "The size of a stone used on a road must be in due proportion to the space occupied by a wheel of ordinary dimensions on a smooth level surface. The point of contact will be found to be longitudinal about 2.5 cm and every piece of stone put into the road which exceeds 2.5 cm in any of its dimension is mischievious" was made by
• Design of highways is based on
• Pick up the correct statement from the following:
• Which one of the following transportation systems is not used for the conveyance of passengers in India?
• For the design of cement concrete pavement for corner loading, Indian Road Congress recommends the use of
• To prevent movement of moisture from subgrade to road pavement on embankments about 0.6 m to 1 m higher than water table, the thickness of cut off layer of coarse sand used, is
• The distance travelled by a moving vehicle during perception and brake reaction times, is known as
• On a pavement with parabolic camber, the angle of inclination of the vehicles will be

Discussion & Comments