Home » Civil Engineering » GATE Exam Questions

On an immersed body in a flowing fluid the lift force is :

due to buoyant force
always in the opposite direction to gravity
due to Wake phenomenon
the dynamic fluid-force component normal to approach velocity

Correct Answer: always in the opposite direction to gravity

← Previous Question Next Question→

More Questions from GATE Exam Questions

Two footings, one circular and the other square, are founded on the surface of a purely cohesionless soil. The diameter of the circular footing is same as that of the side of the square footing. The ratio of their ultimate bearing capcities is
The nature of contact pressure distribution under a rigid footing resting on a sandy soil and subjected to uniformly distributed load is as shown in :
Rivets and bolts subjected to both shear stress (τvf , cal) and axial tensile stress (σtf , cal) shall be so proportioned that the stresses do not exceed the respective allowable stresses τvf and σtf and the value of exceed does not exceed
Compaction by vibratory roller is the best method of compaction in case of
The effective length of a circular electric pole of length L and constant diameters erected on ground is,
A roundabout is provided with an average entry width of 8.4 m, width of weaving section as 14 m, and length of the weaving section between channelizing islands as 35 m. The crossing traffic and total traffic on the weaving section are 1000 and 2000 PCU per hour respectively. The nearest rounded capacity of the roundabout (in PCU per hour) is
A waste water sample diluted to 100 times with aeration water had an initial dissolved oxygen (DO) of 7.0 mg/l and after 5 days of incubation at 20°C, the DO was zero. The BOD of waste water is :
The order or the flexibility matrix for a structure is,
For the strip footing on a saturated clay, for the given failure surface as shown in the below figure, the bearing capacity equation takes the form : (where Cu - undrained shear strength φu - angle of internal friction B - width of strip footing qc - ultimate bearing capacity of soil)
The Bowen ratio is defined as :

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion