Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
GATE Exam Questions
Bituminous materials are commonly use in highway construction because of their good
tensile and compression properties.
binding and water proofing properties.
shear strength and tensile properties.
bond and tensile properties.
Correct Answer:
binding and water proofing properties.
← Previous Question
Next Question→
More Questions from
GATE Exam Questions
A road is provided with a horizontal circular curve having deflection angle of 55° and centre line radius of 250 m. A transition curve is to be provided at each end of the circular curve of such a length that the rate of gain of radial acceleration is 0.3 m/s3 at a speed of 50 km per hour. Length of the transition curve required at each of the ends is
Group symbols assigned to silty sand and clayey sand are respectively
A hyetograph is a graph representing
Cavitation is caused by
Two completely penetrating wells are located L (in metres) apart, in homogeneous confined aquifer. The drawdown measured at the mid point between the two wells (at a distance of 0.5 L from both the wells) is 2.0 m when only the first well is being pumped at the steady rate of Q1 m3/sec. When both the wells are being pumped at identical steady rate of Q2 m3/sec, the drawdown measured at the same location is 8, 0 m. It may be assumed that the drawdown at the wells always remains at 10.0 m when being pumped and the radius of influence is larger than 0.5 L Q1/Q2 is equal to
A test plate 30 cm x 30 cm resting on a sand deposit settles by 10 mm under a certain loading intensity. A footing 150 cm x 200 cm resting on the same sand deposit and loaded to the same load intensity settles by
The stress-strain behaviour of soils as shown in the following figure corresponds to :
For a 'best' symmetrical trapezoidal section of an open channel with a given area of section and side slopes, one of the following statements holds true :
The influence line diagram for the force in member 'a' of the truss shown below is given by
Flow at critical depth takes place in an open channel When
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments