Curioustab

Home » Civil Engineering » Applied Mechanics

The moment of inertia of the shaded portion of the area shown in below figure about the X-axis, is

229.34 cm4
329.34 cm4
429.34 cm4
529.34 cm4.

Correct Answer: 429.34 cm4

← Previous Question Next Question→

More Questions from Applied Mechanics

A rod 5 m in length is moving in a vertical plane. When it is inclined at 60° to horizontal, its lower end is moving horizontally at 3 m/sec and upper end is moving in vertical direction. The velocity of its upper end, is
Pick up the correct statement from the following. A rubber ball when strikes a wall rebounds but a lead ball of same mass and velocity when strikes the same wall, falls down
A ball is dropped from a height of 2.25 m on a smooth floor and rises to a height of 1.00 m after the bounce. The coefficient of restitution between the ball and the floor is
The resultant of two forces acting at right angles is 5 kgf and if they act at an angle of 60°, it is 37 kgf. The magnitudes of the forces are :
If two bodies of masses M1 and M2(M1 > M2) are connected by alight inextensible string passing over a smooth pulley, the tension in the string, will be given by
The force acting on a point on the surface of a rigid body may be considered to act
A square hole is made in a circular lamina, the diagonal of the square is equal to the radius of the circleas shown in below figure the shift in the centre of gravity is
The angle of friction is :
The motion of a particle is described by the relation x = t2- 10t + 30, where x is in metres and t in seconds. The total distance travelled by the particle from t = 0 to t = 10 seconds would be
The member which does not carry zero force in the structure shown in below figure, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion