Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
__________ of water makes it a widely used coolant in heat exchangers.
Low corrosiveness
Low dirt factor
High specific heat
Low viscosity
Correct Answer:
High specific heat
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
Pick out the wrong statement.
Pick out the wrong statement pertaining to the design of a long tube vertical evaporator.
In seive plate column, holes are drilled or punched in sizes ranging from 2.5 to 12 mm (5 mm being widely used). The hole pitch is normally __________ times the hole diameter to give the required hole area.
Which of the following is the most common type of baffle used in industrial shell and tube heat exchanger?
In which of the following evaporators, steam is fed inside the tube while the liquor is outside the tube?
What is the minimum recommended ligament for square pitch arrangement in case of heat exchangers?
Liquid gradient over the tray results due to the
The force due to wind load acting on a tall vessel depends upon its
Pick out the wrong statement.
The safe height (h) to diameter (d) ratio (i.e., h/d) for liquid/petro fuel storage tank of capacity more than 45 kilolitres is less than
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments