Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
Which of the following is the most common type of baffle used in industrial shell and tube heat exchanger?
75% cut segmental baffle.
25% cut segmental baffle.
Orifice baffle.
Disk and doughnut baffle.
Correct Answer:
25% cut segmental baffle.
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
In which of the following evaporators, steam is fed inside the tube while the liquor is outside the tube?
What is the minimum recommended ligament for square pitch arrangement in case of heat exchangers?
Liquid gradient over the tray results due to the
The force due to wind load acting on a tall vessel depends upon its
Pick out the wrong statement.
The safe height (h) to diameter (d) ratio (i.e., h/d) for liquid/petro fuel storage tank of capacity more than 45 kilolitres is less than
A cylinderical pressure vessel of volume 6 πm3 has to be designed to withstand a maximum internal pressure of 10 atm. The allowable design stress of the material is 125N/mm2 and corrosion allowance is 2 mm. The thickness of the vessel for a length/diameter ratio of 3 will be close to
Cylindrical storage tanks used for the storage of volatile liquids (e.g., naphtha) have __________ roofs.
Lug support is meant for supporting __________ vessels.
Fouling factor must be included in the calculation of over all design heat transfer coefficient, when the liquid
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments