Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
In the design of a shell and tube heat exchanger, the corrosion allowance
need not be provided for non-pressure parts like tie rods, spacers, baffles, supports etc.
for carbon steel and cast iron pressure parts is 1.5 mm (except for tubes) and for severe conditions it is 3 mm.
for internal cover and tube sheet is provided on both the sides.
all (a), (b) & (c).
Correct Answer:
all (a), (b) & (c).
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
Flanges are connected to pipes by
__________ shaped roof is most commonly used for cylindrical tanks.
Hold up of material in a operating rotary drier is in the range of
In case of design of a shell and tube heat exchanger,
Commercial packed scrubbers are normally designed for a pressure drop range of __________ mm water coloumn per metre of packed height.
A binary liquid azeotropic mixture has boiling point higher than either of the components, when it shows __________ deviation from Raoult's Law.
Vertical condenser is advantageous to the horizontal condenser from operation point of view, when
In common bubble cap distillation column design practice, riser area is approximately equal to (where, Aa = Annular passage area, and Sa = Slot area)
For storing hazardous chemicals in large storage tanks, the minimum safe distance between the two tanks should range between __________ times the tank diameter.
Theoretically calculated diameter of the stripping section of the continuous rectification column is __________ that of the enriching section.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments