Curioustab

Home » Chemical Engineering » Mechanical Operations

A straight line is obtained on plotting reciprocal of filtration rate vs. the volume of filtrate for __________ flow of filtrate.

compressible cakes and laminar
incompressible cake and laminar
compressible cake and turbulent
incompressible cake and turbulent

Correct Answer: incompressible cake and laminar

← Previous Question Next Question→

More Questions from Mechanical Operations

The reduction ratio for fine grinders is
All resistances during washing of cake
Agglomeration of individual particles into clusters (flocs) is called flocculation. To prevent flocculation, the most commonly used dispersing agents are
Temperature of the product during ultrafine grinding
__________ mills are termed as impactors.
Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for
Size measurement of ultrafine particles can be best expressed in terms of
Which is a secondary crusher for a hard & tough stone?
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
A __________ mixer resembles a ball mill without balls.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion