The reduction ratio for fine grinders is

More Questions from Mechanical Operations

• All resistances during washing of cake
• Agglomeration of individual particles into clusters (flocs) is called flocculation. To prevent flocculation, the most commonly used dispersing agents are
• Temperature of the product during ultrafine grinding
• __________ mills are termed as impactors.
• Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for
• Size measurement of ultrafine particles can be best expressed in terms of
• Which is a secondary crusher for a hard & tough stone?
• Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
• A __________ mixer resembles a ball mill without balls.
• Tank filter (e.g., Nutsch filter) is

Discussion & Comments