Home » Certification » CISCO Certification

To enable RIPng , which of the following would you use?

Router1 (config - if) # ipv6 ospf 10 area 0.0.0.0
Router1 (config - if) # ipv6 router rip 1
Router1 (config - if) # ipv6 router eigrp 10
Router1 (config - if) # ospf ipv6 10 area 0

Correct Answer: Router1 (config - if) # ipv6 router rip 1

Explanation:

It's pretty simple to enable RIPng for IPv6. You configure it right on the interface where you want RIP to run with the ipv6 router rip number command.

← Previous Question Next Question→

More Questions from CISCO Certification

What multicast addresses does EIGRPv6 use?
What multicast addresses does RIPng use?
Which of the following is true when describing a multicast address?
What does a link-local address always start with?
Suppose you have a customer who has a central HQ and six branch offices. The customer anticipates adding six more branches in the near future. It whishes to implement a WAN technology that will allow the branches to economically connect to HQ and you have no free ports on the HQ router. which of the following would you recommend?
When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
The Acme Corporation is implementing dail-up services to enable remote-office employees to connect to the local network. The company uses multiple routed protocols,needs authentication of users connecting to the network, and since some calls will be long distance, needs callback support. Which of the following protocols is the best choice for these remote services?
Which of the following uses ATM as the Data Link layer protocol that's terminated at what's known as the DSLAM?
What is the full IPv6 address represented by FF02::130F:5?
What are the access, distribution, and core components of a North American phone number?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion