Home » Certification » CISCO Certification

The DoD model (also called the TCP/IP stack) has four layers. Which layer of the DoD model is equivalent to the Network layer of the OSI model?

Application
Host-to-Host
Internet
Network Access

Correct Answer: Internet

Explanation:

The four layers of the DoD model are Application/process, Host-to-Host, Internet, and Network Access. The Internet layer is equivalent to the Network layer of the OSI model.

← Previous Question Next Question→

More Questions from CISCO Certification

Which of the following protocols uses both TCP and UDP?
Differentiate the DoD and the OSI network models?
If a host on a network has the address 172.16.45.14/30, what is the subnetwork this host belongs to?
You need to subnet a network that has 5 subnets, each wit at least 16 hosts. Which classful subnet mask would you use?
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?
What is the command to copy the startup-config filre to DRAM?
A network administrator views the output from the show ip route command. A network that is advertised by both RIP and EIGRP appears in the routing table flagged as an EIGRP route. why is the RIP route to this network not used in the routing table?
If your routing table has a static, a RIP, and an EIGRP route to the same network, which route will be used to route packets by default?
There are three possible routes for a router to reach a destination network. The first route is from OSPF with a metric of 782. The second route is from RIPv2 with a metric of 4. The third is from EIGRP with a composite metric of 20514560. Which route will be installed by the router in its routing table?
What four routed protocols are supported by EIGRP?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion