Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Oblique Projection
In general, all types of sections for isometric drawing may be applied to oblique drawing.
True
Correct Answer:
True
← Previous Question
Next Question→
More Questions from
Oblique Projection
If a complicated pictorial is needed, it may be easier and more accurate to create a 3D model than an oblique drawing.
In an oblique drawing, when an angle is specified in degrees in a receding plane, you should convert the angle into circular measurements.
In oblique projections, one of the object's principal faces is parallel to the plane of projection.
When the receding lines are drawn to half size, the drawing is known as a cabinet projection.
In CAD, oblique drawings are difficult to create because you cannot use snap increments or draw similarly to drawing on grid paper.
In oblique projections, the projectors are perpendicular to each other but are not parallel to the plane of projection.
Circles, circular arcs, and other curved surfaces may be drawn using offset measurements.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments