Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is

bending
deformation
shear
elongation

Correct Answer: bending

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Steam economy is defined as the amount of evaporation per unit amount of steam used, while the capacity is the total evaporation obtained per hour. Use of multiple effect in evaporation
Souders Brown equation given by, , is used for the calculation of the __________ in a continuous distillation column.
What is the slope of the feed line, if the feed to a distillation column is a saturated liquid?
The ratio of volumes of the mixed reactor to the plug flow reactor (for identical feed composition, flow rate, conversion, and for all positive reaction orders) is always
In a double pipe (concentric) heat exchanger, the hydraulic radius for heat transfer (for a fluid flowing through the annulus) would be
Pressure differential maintained across a continuous rotary vacuum filter is in the range of __________ mm Hg column.
Liquid gradient over a tray can be minimised by
Scale up problem in design based on the similarity concept takes into account __________ similarity.
Tubes are fixed to the tube sheet (a thick circular metallic plate) by the method of tube rolling and brazing (non-removable) or ferrule connection (removable). Thickness of the tube, sheet is normally __________ the outside diameter of the tube but in no case it should be less than 22 mm (7/8").
Cylinderical shell thickness of rotary drier is generally __________ mm.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion