Workshop Technology problems
- 1. Spot welding is used for welding
Options- A. lap joints in plates having 0.025 mm to 1.25 mm thickness
- B. lap joints in plates having thickness above 3 mm
- C. butt joints in plates having 0.025 mm to 1.25 mm thickness
- D. butt joints in plates having thickness above 3 mm Discuss
Correct Answer: lap joints in plates having 0.025 mm to 1.25 mm thickness
- 2. The directional solidification in casting can be improved by using
Options- A. chills and chaplets
- B. chills and padding
- C. chaplets and padding
- D. chills, chaplets and padding Discuss
Correct Answer: chills and padding
- 3. In tungsten-inert gas arc welding, a __________ electrode is used.
Options- A. consumable
- B. non-consumable Discuss
Correct Answer: non-consumable
- 4. The minimum size of a billet is 10 cm x 10 cm.
Options- A. Agree
- B. Disagree Discuss
Correct Answer: Disagree
- 5. The cold chisels are made from
Options- A. cast iron
- B. mild steel
- C. high speed steel
- D. cast tool steel Discuss
Correct Answer: cast tool steel
- 6. The casting method adopted for ornaments and toys of non-ferrous alloys, is
Options- A. permanent mould casting
- B. slush casting
- C. die casting
- D. centrifugal casting Discuss
Correct Answer: slush casting
- 7. In welding magnesium with TIG arc welding, direct current with __________ is used.
Options- A. straight polarity
- B. reversed polarity Discuss
Correct Answer: reversed polarity
- 8. Thermit welding is often used in
Options- A. replacing broken gear teeth
- B. repairing broken shears
- C. joining rails, truck frames and locomotive frames etc.
- D. all of the above Discuss
Correct Answer: all of the above
- 9. Structural sections such as rails, angles, I-beams are made by
Options- A. hot rolling
- B. hot drawing
- C. hot piercing
- D. hot extrusion Discuss
Correct Answer: hot rolling
- 10. For gas welding, the presure desired at the welding torch for acetylene is
Options- A. 7 to 103 kN/m2
- B. 70 to 280 kN/m2
- C. 280 to 560 kN/m2
- D. 560 to 840 kN/m2 Discuss
Correct Answer: 7 to 103 kN/m2
More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.