logo

CuriousTab

CuriousTab

IC Engines and Nuclear Power Plants problems


  • 1. If petrol is used in a diesel engine, then

  • Options
  • A. low power will be produced
  • B. efficiency will be low
  • C. higher knocking will occur
  • D. black smoke will be produced
  • Discuss
  • 2. In a four stroke cycle petrol engine, the expansion

  • Options
  • A. starts at top dead centre and ends at bottom dead centre
  • B. starts at 30° before top dead centre and ends at 50° before bottom dead centre
  • C. starts at 30° after top dead centre and ends at 50° after bottom dead centre
  • D. may start and end anywhere
  • Discuss
  • 3. During idling, a petrol engine requires __________ mixture.

  • Options
  • A. lean
  • B. rich
  • C. chemically correct
  • Discuss
  • 4. The brake power is always greater than indicated power.

  • Options
  • A. Agree
  • B. Disagree
  • Discuss
  • 5. The sensing element in the control system of nuclear reactors measure the __________ of the neutron flux in the reactor.

  • Options
  • A. temperature
  • B. volume
  • C. density
  • D. none of these
  • Discuss
  • 6. The method of determination of indicated power of a multi cylinder spark ignition engine is by the use of

  • Options
  • A. Morse test
  • B. prony brake test
  • C. motoring test
  • D. heat balance test
  • Discuss
  • 7. The first nuclear power plant in India was located at

  • Options
  • A. Kota
  • B. Tarapur
  • C. Bareilly
  • D. none of these
  • Discuss
  • 8. Which of the following statement is correct regarding normal cetaine?

  • Options
  • A. It is a standard fuel used for knock rating of diesel engines.
  • B. Its chemical name is normal-hexadecane.
  • C. It has long carbon chain structure.
  • D. all ofthe above
  • Discuss
  • 9. The probability of knocking in diesel engines is increased by

  • Options
  • A. high self ignition temperature
  • B. low volatility
  • C. higher viscosity
  • D. all of these
  • Discuss
  • 10. Enriched uranium is required as a fuel in a nuclear reactor, if light water is used as moderator and coolant, because light water has

  • Options
  • A. high neutron absorption cross-section
  • B. low moderating efficiency
  • C. high neutron scatter cross-section
  • D. low neutron absorption cross-section
  • Discuss

First 19 20 21 ... .. 22 Last