analog-electronics electronics-and-communication-engineering question and answers -Page 5

CuriousTab

CuriousTab

Home Aptitude

Analog Electronics problems

1. The load impedance Z_L of a CE amplifier has R and L in series. The phase difference between output and input will be
Options
A. 180�
B. 0
C. more than 90� but less than 180�
D. more than 180� but less than 270�

2. An amplifier with loop gain A? will be more stable for value of A? as
Options
A. 0.95
B. 0.7
C. 1.2
D. 1.5

3. A bridge rectifier circuit has input of 50 Hz frequency. The load resistance is R_L and filter capacitance is C. For good output wave shape, the time constant R_LC should be at least equal to
Options
A. 10 ms
B. 20 ms
C. 50 ms
D. 100 ms

4. In figure The minimum and maximum load currents are
Options
A. 0 and 60 mA
B. 0 and 120 mA
C. 10 mA and 60 mA
D. 10 mA and 120 mA

6. Consider the following statements : A clamper circuit
1. adds or subtracts a dc voltage to a waveform
2. does not change the waveform
3. amplifiers the waveform
Which are correct?
Options
A. 1, 2
B. 1, 3
C. 1, 2, 3
D. 2, 3

7. Gain of the amplifier is 'A'. Then the I/P impedance and O/P impedance of the closed loop amplifier shown below would be
Options
A.
B.
C.
D.

8. In a CE amplifier the input impedance is equal to the ratio of
Options
A. ac base voltage to ac base current
B. ac base voltage to ac emitter current
C. ac emitter voltage to ac collector current
D. ac collector voltage to ac collector current

First 2 3 4 5

More in Electronics and Communication Engineering: