Automation System problems
- 1. One of the major benefits of using CAD in tool design is that:
Options- A. product design represents approximately one-half the engineering costs
- B. tool motions can be checked to see if there is interference between the tool and the object
- C. there is better coordination in the materials-handling area
- D. it simplifies the trial-and-error method
- E. None of the above Discuss
Correct Answer: tool motions can be checked to see if there is interference between the tool and the object
- 2. For a type 0 system, the steady-state:
Options- A. error for a step input is always zero
- B. error for a velocity input is always zero
- C. input for acceleration input is always non-zero
- D. (a) and (c)
- E. None of the above Discuss
Correct Answer: input for acceleration input is always non-zero
- 3. Which of the following is required for a plotter to perform specific commands?
Options- A. Firmware
- B. Software
- C. Driver
- D. Hardware
- E. None of the above Discuss
Correct Answer: Driver
- 4. Which of the following elements can be used with a TI510 FC?
Options- A. Drum timer
- B. Metronome
- C. Cymbal timer
- D. Flashing light
- E. None of the above Discuss
Correct Answer: Drum timer
- 5. A typical NC system has which of the following components?
Options- A. Controller
- B. Tape input
- C. Machine tool
- D. All of the above
- E. None of the above Discuss
Correct Answer: All of the above
- 6. Which part of the system performs the "housekeeping" chores?
Options- A. operating system
- B. compiler
- C. interpreter
- D. translator
- E. None of the above Discuss
Correct Answer: operating system
- 7. The steady-state error is:
Options- A. independent of the type of input
- B. a function of the transient response
- C. zero for all inputs to type 1 systems
- D. decreased by increasing gain.
- E. None of the above Discuss
Correct Answer: decreased by increasing gain.
- 8. A pick-and-place manipulator is:
Options- A. the most flexible of all robots
- B. an intelligent robot
- C. capable of point-to-point operation
- D. primarily used for large parts handling
- E. None of the above Discuss
Correct Answer: capable of point-to-point operation
- 9. Most current PC CAD systems are used for producing:
Options- A. solids modeling
- B. 2-D drawings
- C. circuit simulation
- D. finite element analysis
- E. None of the above Discuss
Correct Answer: 2-D drawings
- 10. Use of modern control technology in automation systems:
Options- A. reduces costs
- B. improves reliability
- C. increases yield
- D. All of the above
- E. None of the above Discuss
Correct Answer: All of the above
More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.