logo

CuriousTab

CuriousTab

Mass Transfer problems


  • 1. Which of the following is the most suitable for extraction in a system having very low density difference?

  • Options
  • A. Mixer-settler extractor
  • B. Centrifugal extractor
  • C. Pulsed extractor
  • D. Packed extraction tower
  • Discuss
  • 2. Low viscosity absorbent is preferred for reasons of

  • Options
  • A. rapid absorption rates and good heat transfer characteristics.
  • B. improved flooding characteristics.
  • C. low pressure drop on pumping.
  • D. all (a), (b) and (c).
  • Discuss
  • 3. Raoult's law applies to the

  • Options
  • A. all liquid solutions
  • B. non-ideal solution only.
  • C. non-volatile solute.
  • D. solvents.
  • Discuss
  • 4. Which of the following quantities need not be fixed before starting the design of a co-current absorber?

  • Options
  • A. Heat gain or loss
  • B. Flow rate of entering liquid
  • C. Flow rate of gas
  • D. None of these
  • Discuss
  • 5. Psychrometry deals with the properties of gas-vapor mixture. Humidity can be determined by the measurement of the __________ of a fibre.

  • Options
  • A. electrical resistance
  • B. thermal conductivity
  • C. strength
  • D. none of these.
  • Discuss
  • 6. Absorption accompanied with chemical reaction is exemplified by the absorption of

  • Options
  • A. ammonia in water.
  • B. benzol present in coke oven gas by wash oil.
  • C. SO2 in alkaline solution.
  • D. all (a), (b) and (c).
  • Discuss
  • 7. Physical absorption is

  • Options
  • A. an irreversible phenomenon.
  • B. a reversible phenomenon.
  • C. accompanied by evolution of heat.
  • D. both (b) and (c)
  • Discuss
  • 8. In a packed absorption tower, if the equilibrium and operating lines are both straight lines, then the ratio, HETP/HTUOG __________ the absorption factor.

  • Options
  • A. increases with increase in
  • B. is one at unity value of
  • C. both (a) and (b)
  • D. neither (a) nor (b)
  • Discuss
  • 9. Make up water is required in a cooling tower to replace the water lost by

  • Options
  • A. evaporation
  • B. drift
  • C. blowdown and leakage
  • D. all (a), (b) and (c)
  • Discuss
  • 10. Pick out the correct statement.

  • Options
  • A. In case of liquid-liquid extraction, no separation is possible, if the selectivity of the solvent used is unity.
  • B. With increase in temperature, the selectivity of the solvent used in solvent extraction decreases.
  • C. The selectivity of solvent used in solvent extraction is unity at the plait point.
  • D. all (a), (b) and (c).
  • Discuss

First 2 3 4