Which of the following is true regarding access lists applied to an interface?

You can place as many access lists as you want on any interface until you run out of memory.
You can apply only one access list on any interface.
One access list may be configured, per direction, for each layer 3 protocol configured on an interface.
You can apply two access lists to any interface.

Correct Answer: One access list may be configured, per direction, for each layer 3 protocol configured on an interface.

Explanation:

A Cisco router has rules regarding the placement of access lists on a router interface. You can place one access list per direction for each layer 3 protocol configured on an interface.

← Previous Question Next Question→

More Questions from Security

Which command would you use to apply an access list to a router interface?
Which of the following is an example of a standard IP access list?
What command will permit SMTP mail to only host 1.1.1.1?
You configure the following access list: access-list 110 deny tcp 10.1.1.128 0.0.0.63 any eq smtp access-list 110 deny tcp any eq 23 int ethernet 0 ip access-group 110 out What will the result of this access list be?
If you wanted to deny all Telnet connections to only network 192.168.10.0, which command could you use?
You have created a named access list called Blocksales. Which of the following is a valid command for applying this to packets trying to enter interface s0 of your router?
Which of the following access lists will allow only HTTP traffic into network 196.15.7.0?
You want to create a standard access list that denies the subnet of the following host: 172.16.144.17/21. Which of the following would you start your list with?
What router command allows you to determine whether an IP access list is enabled on a particular interface?
Which of the following commands connect access list 110 inbound to interface ethernet0?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion