Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Engineering Mechanics
A circular hole of 50 mm diameter is cut out from a circular disc of 100 mm diameter as shown in the below figure. The centre of gravity of the section will lie
in the shaded area
in the hole
at O
Correct Answer:
in the shaded area
← Previous Question
Next Question→
More Questions from
Engineering Mechanics
Mass moment of inertia of a thin rod about its one end is __________ the mass moment of inertia of the same rod about its mid-point
Frequency of vibrations means the number of cycles per second.
If a pendulum is taken 1 km below the earth surface in a mine, it will __________ in time.
The moment of inertia of a square of side a about its base is a4/ 3.
If tension in the cable supporting a lift moving downwards is half the tension when it is moving upwards, the acceleration of the lift is
Coplaner concurrent forces are those forces which
The loss of kinetic energy due to direct impact of two bodies __________ upon the value of coefficient of restitution.
The unit of power in S.I. units is
The centre of gravity of a right angled triangle lies at its geometrical centre.
If the gravitational acceleration at any place is doubled, then the weight of a body will be
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments