Curioustab

Home » Electronics » Time Response of Reactive Circuits

What has the voltage across the resistor decayed to by the end of the pulse in the given circuit?

0 V
0.75 V
5.55 V
14.25 V

Correct Answer: 0.75 V

← Previous Question Next Question→

More Questions from Time Response of Reactive Circuits

The output voltage of an RC integrator will eventually equal the voltage of a single input pulse if the input pulse width is less than 5 time constants.
A differentiator circuit can be used to convert a pulse input to a nearly constant dc output.
During the steady-state condition of a differentiator, the average output voltage is zero volts.
The voltage across a capacitor in an RC integrator circuit cannot change exponentially; it can change only instantaneously.
The output voltage of a differentiator goes negative on the falling edge of the input pulse.
The output of a differentiator could be considered a spike when the input pulse width is much longer than 5 time constants.
The steady-state condition of an integrator is reached after 5 time constants regardless of the number of input pulses that occur in that amount of time.
The output of an RC differentiator is taken from across the capacitor.
If the output of an RC integrator is zero volts, the capacitor might be open.
A repetitive pulse with a 50% duty cycle is being applied to the input of an RC integrator. If one time constant is less than one-fifth the pulse width, the capacitor will be able to fully charge and discharge.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion