Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics
»
Operational Amplifiers
An open feedback resistor in an inverting or noninverting op-amp circuit can cause severe clipping of the output signal.
True
Correct Answer:
True
← Previous Question
Next Question→
More Questions from
Operational Amplifiers
An S-R flip-flop is an example of a bistable multivibrator circuit.
The frequency of a crystal is dependent on how much voltage is applied to activate it.
If the two inputs to a differential amplifier are exactly the same, then the output is the signal multiplied by two.
If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.
A monostable multivibrator must be triggered.
The difference between the upper and lower trigger points is called the Schmitt trigger.
The inverting input is pin 2.
A voltage-follower op-amp has the output connected directly to the inverting input.
This circuit is a bandpass filter.
The voltage gain of the amplifier in the given circuit would increase if ______.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments