Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics and Communication Engineering
»
Microwave Communication
The component in the given figure is
attenuator
T type low pass filter
T type high pass filter
phase shifter
Correct Answer:
T type low pass filter
Explanation:
Z
01
provides series inductances and teflon filled low impedance line Z
02
provides shunt capacitance.
← Previous Question
Next Question→
More Questions from
Microwave Communication
A pulsed radar produces 1 μ sec pulses at a rate of 1000 per second. The duty cycle is
Assertion (A): Impedance measurement at microwave frequencies is done by finding SWR. Reason (R): SWR and reflection coefficient depend on the characteristic impedance and load impedance.
A klystron amplifier generally uses Pierce gun
Consider the following applications TV tuning Active filter Microwave frequency multiplication In which of above can a varactor diode be used?
When a line is loaded the characteristic impedance is equal to
If a line having Z0 = 300 ∠ 0 W is short circuited at far end, VSWR is
A reflex klystron oscillator uses
Ga As exhibits negative differential mobility
Microwave links are typically 50 km apart
If antenna diameter is increased four times, the maximum range is increased by a factor of
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments