Home » Electronics and Communication Engineering » Matching Questions

Match the following: List I (Diode Rectifier) List II (Expression for output voltage) A. Bridge 1. B. Half wave 2. C. Full wave using centre tapped transformer 3.

A-1, B-2, C-3
A-3, B-2, C-1
A-1, B-3, C-2
A-3, B-1, C-2

Correct Answer: A-1, B-3, C-2

← Previous Question Next Question→

More Questions from Matching Questions

Match the following: List I List II A. Laser 1. Emits monochromatic light of low intensity B. Solar cell 2. Consumes electrical power due to incident light C. Photodiode 3. Delivers power to a load D. LED 4. Emits monochromatic light of high intensity
Match the following: List I (Characteristics) List II (Device) A. Voltage controlled device 1. BJT B. Current controlled device 2. UJT C. Conductivity modulation device 3. FET D. Negative conductance device 4. Impatt diode
Match the following: List I List II A. CTFS 1. Periodic B. DTFS 2. Non-periodic C. CTFT D. DTFT
Match the following: List I List II A. Bode 1. Asymptotic plots B. Evans 2. Polar plots C. Nyquist 3. Root locus technique 4. M and N circles
Match the following: List I List II A. Very low response at very high frequencies 1. Low-pass system B. Over shoot 2. Velocity damping C. Synchro-control transformer output 3. Natural frequency 4. Phase-sensitive modulation 5. Damping ratio
Match the following: List I List II A. 1. Slot line B. 2. Coplanar line C. 3. Microstrip
Match the following: List I List II A. 1. Circles B. 2. Straight lines C. 3. Hyperbolas D.
Match the following: List I (Form) List II (Network) A. Cauer I 1. L in series arm and C in shunt arm of ladder B. Cauer II 2. C in series arm and L in shunt arm of ladder C. Foster I 3. Series combination of L and C in parallel D. Foster II 4. Parallel combination of L and C in series
List I List II (Value of tan-1 ) A. 1. 90° B. 2. 0° C. 3. 50°
Match the following: List I List II A. 45 1. 10110100 B. 90 2. 11010010 C. 180 3. 01011010 D. 210 4. 00101101 5. 10101000

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion