Discussion
Home ‣ Digital Electronics ‣ Digital Signal Processing Comments
- Question
A standard logic device can be connected on a bus system as an open-collector logic device by connecting each output to a ________.
Options- A. discrete transistor
- B. 10 kΩ series resistor
- C. light-emitting diode
- D. CMOS buffer
- Correct Answer
- discrete transistor
- 1. Assume that in a certain 4-bit weighted ladder DAC, the input representing the most significant bit is applied to a 20 kΩ resistor. What is the size of the resistor that represents the least significant bit?
Options- A. 2.5 kΩ
- B. 5 kΩ
- C. 80 kΩ
- D. 160 kΩ Discuss
- 2. An offset error in a DAC will show up as an incorrect analog output ________.
Options- A. only for higher value inputs
- B. only for lower value inputs
- C. only for certain (scattered) inputs
- D. for all inputs Discuss
- 3. The principal advantage of the three-wire handshake on the GPIB is that it ________.
Options- A. is faster than two-wire methods
- B. allows fast and slow listeners on the same bus
- C. can be used over very long distances
- D. is compatible with the RS232C standard Discuss
- 4. The ADC0804 is an example of a successive-approximation ADC.
Options- A. True
- B. False Discuss
- 5. Digital signal processors must be programmed to perform specific tasks.
Options- A. True
- B. False Discuss
- 6. Of the methods listed, the fastest A/D conversion is done by a ________.
Options- A. single-slope ramp converter
- B. dual-slope ramp converter
- C. successive-approximation converter
- D. tracking converter Discuss
- 7. The number of data lines on the GPIB is ________.
Options- A. 1
- B. 4
- C. 8
- D. 16 Discuss
- 8. A monotonicity error in a DAC will show up as an incorrect analog output ________.
Options- A. only for higher value inputs
- B. only for lower value inputs
- C. only for certain (scattered) inputs
- D. for all inputs Discuss
- 9. The resolution of a DAC can be expressed as the ________.
Options- A. minimum output voltage
- B. number of bits that are converted to an analog output
- C. deviation of the output from a straight line
- D. difference between the expected and actual outputs Discuss
- 10. An ADC that compares each bit, one at a time, with the input analog signal is a ________.
Options- A. single-slope ramp converter
- B. dual-slope ramp converter
- C. successive-approximation converter
- D. tracking converter Discuss
Digital Signal Processing problems
Search Results
Correct Answer: 160 kΩ
Correct Answer: for all inputs
Correct Answer: allows fast and slow listeners on the same bus
Correct Answer: True
Correct Answer: True
Correct Answer: successive-approximation converter
Correct Answer: 8
Correct Answer: only for certain (scattered) inputs
Correct Answer: number of bits that are converted to an analog output
Correct Answer: successive-approximation converter
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.