Discussion
Home ‣ Digital Electronics ‣ Logic Families and Their Characteristics Comments
- Question
The basic part numbers of ICs are the same regardless of the manufacturer because digital logic ICs have been standardized.
Options- A. True
- B. False
- Correct Answer
- True
- 1. In ECL, the HIGH and LOW levels are determined by which transistor in a differential amplifier is conducting more.
Options- A. True
- B. False Discuss
- 2. PMOS and NMOS are commonly used for small memories and microprocessors.
Options- A. True
- B. False Discuss
- 3. In TTL the noise margin is between 0.8 V and 0.4 V.
Options- A. True
- B. False Discuss
- 4. A pulse is not perfectly square; it takes time for the digital level to rise from 0 up to 1 and to fall from 1 down to 0.
Options- A. True
- B. False Discuss
- 5. Propagation delay in TTL is due to slow switching speeds.
Options- A. True
- B. False Discuss
- 6. Schottky logic overcomes the saturation and stored charge problem by placing a Schottky diode across the base-to-collector junction.
Options- A. True
- B. False Discuss
- 7. A typical fan-out for most TTL is 9.
Options- A. True
- B. False Discuss
- 8. Power-supply decoupling uses a radio-frequency capacitor to short out high frequency spikes.
Options- A. True
- B. False Discuss
- 9. The CMOS series that is pin-compatible with the TTL family is the 4000 series.
Options- A. True
- B. False Discuss
- 10. The fan-out of CMOS gates is frequency dependent.
Options- A. True
- B. False Discuss
Logic Families and Their Characteristics problems
Search Results
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.