Discussion
Home ‣ Digital Electronics ‣ The 8051 Microcontroller Comments
- Question
The 8051 is a 40-pin IC. Twenty-two pins are needed for the four I/O ports.
Options- A. True
- B. False
- Correct Answer
- False
- 1. A monostable multivibrator is commonly called a two shot.
Options- A. True
- B. False Discuss
- 2. A multivibrator is a circuit that changes between two digital levels on a continuous, free-running basis or on demand.
Options- A. True
- B. False Discuss
- 3. The 74S124 TTL chip is a voltage-controlled oscillator that will generate a specific frequency at Vout.
Options- A. True
- B. False Discuss
- 4. Timing accuracy of more than eight significant digits can be easily achieved by using quartz crystals.
Options- A. True
- B. False Discuss
- 5. When the 74123, a retriggerable monostable multivibrator device, ends its timing cycle it must be started all over again.
Options- A. True
- B. False Discuss
- 6. Different instruction sets must make up for the various members of the 8051 family.
Options- A. True
- B. False Discuss
- 7. The RST pin requires a HIGH to reset the 8051 microcontroller.
Options- A. True
- B. False Discuss
- 8. Up to 65K of code memory and 65K of data memory can be added to any of the 8051 family members.
Options- A. True
- B. False Discuss
- 9. In an 8051 program DA A adjusts the value in the accumulator resulting from an addition into two BCDs.
Options- A. True
- B. False Discuss
- 10. Writing counter/loop programs is much more difficult with the introduction of the DJNA and the CJNE instructions.
Options- A. True
- B. False Discuss
The 8051 Microcontroller problems
Search Results
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.