Discussion
Home ‣ Digital Electronics ‣ Multivibrators and 555 Timer Comments
- Question
A single Schmitt trigger inverter is all that is needed to build a simple astable multivibrator.
Options- A. True
- B. False
- Correct Answer
- False
- 1. The bistable multivibrator is an R-C flip-flop.
Options- A. True
- B. False Discuss
- 2. The input levels to a flip-flop must be maintained for a minimum time period both before and after the edge of the clock signal is applied.
Options- A. True
- B. False Discuss
- 3. The 7805 will get very hot if your circuit draws more than 0.5 A.
Options- A. True
- B. False Discuss
- 4. There is no way to eliminate the effects of a switch bounce.
Options- A. True
- B. False Discuss
- 5. A transfer function graph illustrates the most important specifications for the Schmitt trigger devices.
Options- A. True
- B. False Discuss
- 6. In the 74121, which is nonretriggerable, any triggers that come in before the end of the timing cycle are ignored.
Options- A. True
- B. False Discuss
- 7. When extremely critical timing is required, a quartz crystal can be used.
Options- A. True
- B. False Discuss
- 8. A comparator simply outputs a HIGH or LOW based on a comparison of the voltage levels at its input.
Options- A. True
- B. False Discuss
- 9. When the 74123, a retriggerable monostable multivibrator device, ends its timing cycle it must be started all over again.
Options- A. True
- B. False Discuss
- 10. Timing accuracy of more than eight significant digits can be easily achieved by using quartz crystals.
Options- A. True
- B. False Discuss
Multivibrators and 555 Timer problems
Search Results
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.