Discussion
Home ‣ Electronics ‣ Arithmetic Operations and Circuits Comments
- Question
One advantage of using the 2's complement system to represent signed numbers is that you ___________.
Options- A. can perform subtraction by performing addition
- B. can perform addition by performing subtraction
- C. can perform division through repeated subtraction
- D. none of the above
- Correct Answer
- can perform subtraction by performing addition
- 1. Two 4-bit adders could be cascaded to form a(n) ___________.
Options- A. 16-bit parallel-adder circuit
- B. 8-bit parallel-adder circuit
- C. full-adder circuit
- D. arithmetic-logic unit Discuss
- 2. In binary number systems the sign of a number is indicated by _________.
Options- A. using a 0 (zero) bit in front of negative numbers
- B. inverting the bits if the number is negative
- C. including a sign bit along with the magnitude bits
- D. placing a negative sign in front of the number Discuss
- 3. An input to the mode pin of an arithmetic-logic unit (ALU) determines if the function will be _________.
Options- A. one's complemented
- B. positive or negative
- C. with or without carry
- D. arithmetic or logic Discuss
- 4. All digital systems that perform arithmetic operations must indicate _______ and ________ for numbers.
Options- A. size, base
- B. sign, magnitude
- C. sign, base
- D. magnitude, base Discuss
- 5. The carry propagation delay in 4-bit full-adder circuits ____________.
Options- A. is normally not a consideration because the delays are usually in the nanosecond range
- B. is cumulative for each stage and limits the speed at which arithmetic operations are performed
- C. decreases in direct ratio to the total number of full-adder stages
- D. increases in direct ratio to the total number of full-adder stages, but is not a factor in limiting the speed of arithmetic operations Discuss
- 6. The 1's complement of 1010102 is _________.
Options- A. 0101102
- B. 0101012
- C. 1101112
- D. 1010112 Discuss
- 7. The bits of a number that tell how large the number is are called ____________________.
Options- A. carry bits
- B. magnitude bits
- C. sign bits
- D. most significant bits Discuss
- 8. Incorrect codes are a form of output error for a digital-to-analog converter (DAC).
Options- A. True
- B. False Discuss
- 9. The key advantage of the successive approximation analog-to-digital converter (ADC) is its conversion speed.
Options- A. True
- B. False Discuss
- 10. In a binary-weighted digital-to-analog converter (DAC), the values of the input resistors are chosen to be proportional to the binary weights of the corresponding input bits.
Options- A. True
- B. False Discuss
Arithmetic Operations and Circuits problems
Search Results
Correct Answer: 8-bit parallel-adder circuit
Correct Answer: including a sign bit along with the magnitude bits
Correct Answer: arithmetic or logic
Correct Answer: sign, magnitude
Correct Answer: is cumulative for each stage and limits the speed at which arithmetic operations are performed
Correct Answer: 0101012
Correct Answer: magnitude bits
Correct Answer: False
Correct Answer: True
Correct Answer: False
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.