Discussion
Home ‣ Electronics ‣ Flip-Flops and Timers Comments
- Question
The 555 timer can be used in either the bistable mode or the monostable mode.
Options- A. True
- B. False
- Correct Answer
- False
- 1. Edge-triggered flip-flops can be identified by the triangle on the clock input.
Options- A. True
- B. False Discuss
- 2. Pulse-triggered flip-flops are identified by a bubble on the Q output terminal.
Options- A. True
- B. False Discuss
- 3. When using master-slave flip-flops, the data is entered into the flip-flop on the leading edge of the clock, but the output does not change until the trailing edge of the clock.
Options- A. True
- B. False Discuss
- 4. Multivibrators must be level-triggered.
Options- A. True
- B. False Discuss
- 5. A check of all power supply voltages should be made during the ________ method of troubleshooting.
Options- A. half-split
- B. diagnosis
- C. repair
- D. final test Discuss
- 6. A one-shot is a special type of multivibrator, which must be triggered to produce each output pulse.
Options- A. True
- B. False Discuss
- 7. A D-type flip-flop is constructed by connecting an inverter between the Set and Clock terminals.
Options- A. True
- B. False Discuss
- 8. When the S and the R inputs are both HIGH the output of an S-R NOR latch will be unpredictable.
Options- A. True
- B. False Discuss
- 9. J-K flip-flops are often used as switch debouncers.
Options- A. True
- B. False Discuss
- 10. The J-K flip-flop eliminates the RACE state when both the J and K inputs are HIGH.
Options- A. True
- B. False Discuss
Flip-Flops and Timers problems
Search Results
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: half-split
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.