logo

CuriousTab

CuriousTab

Discussion


Home Electronics Flip-Flops and Timers Comments

  • Question
  • Edge-triggered flip-flops can be identified by the triangle on the clock input.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 


  • Flip-Flops and Timers problems


    Search Results


    • 1. Pulse-triggered flip-flops are identified by a bubble on the Q output terminal.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. When using master-slave flip-flops, the data is entered into the flip-flop on the leading edge of the clock, but the output does not change until the trailing edge of the clock.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. Multivibrators must be level-triggered.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. A check of all power supply voltages should be made during the ________ method of troubleshooting.

    • Options
    • A. half-split
    • B. diagnosis
    • C. repair
    • D. final test
    • Discuss
    • 5. The results of internal IC failures will usually be noticed during the ______ phase of troubleshooting.

    • Options
    • A. diagnostic
    • B. isolation
    • C. repair
    • D. final test
    • Discuss
    • 6. The 555 timer can be used in either the bistable mode or the monostable mode.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. A one-shot is a special type of multivibrator, which must be triggered to produce each output pulse.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. A D-type flip-flop is constructed by connecting an inverter between the Set and Clock terminals.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. When the S and the R inputs are both HIGH the output of an S-R NOR latch will be unpredictable.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. J-K flip-flops are often used as switch debouncers.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment