logo

CuriousTab

CuriousTab

Discussion


Home Electronics Testing and Troubleshooting Comments

  • Question
  • A check of all power supply voltages should be made during the ________ method of troubleshooting.


  • Options
  • A. half-split
  • B. diagnosis
  • C. repair
  • D. final test

  • Correct Answer
  • half-split 


  • Testing and Troubleshooting problems


    Search Results


    • 1. The results of internal IC failures will usually be noticed during the ______ phase of troubleshooting.

    • Options
    • A. diagnostic
    • B. isolation
    • C. repair
    • D. final test
    • Discuss
    • 2. The use of a logic probe may be improved through the use of a(n) ________.

    • Options
    • A. logic clip
    • B. frequency counter
    • C. oscilloscope
    • D. current tracer
    • Discuss
    • 3. In order for a logic probe to operate, its red and black leads must first be connected to a ________.

    • Options
    • A. logic clip
    • B. HIGH or TRUE signal
    • C. power source
    • D. logic pulser
    • Discuss
    • 4. The device that would best aid in open track detection is a(n) ________.

    • Options
    • A. multimeter
    • B. current tracer
    • C. logic probe
    • D. oscilloscope
    • Discuss
    • 5. "Train" and "single" is the mode selection for a _______.

    • Options
    • A. multimeter
    • B. logic probe
    • C. current tracer
    • D. logic pulser
    • Discuss
    • 6. Multivibrators must be level-triggered.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. When using master-slave flip-flops, the data is entered into the flip-flop on the leading edge of the clock, but the output does not change until the trailing edge of the clock.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. Pulse-triggered flip-flops are identified by a bubble on the Q output terminal.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. Edge-triggered flip-flops can be identified by the triangle on the clock input.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. The 555 timer can be used in either the bistable mode or the monostable mode.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment