logo

CuriousTab

CuriousTab

Discussion


Home Electronics Testing and Troubleshooting Comments

  • Question
  • The device that would best aid in open track detection is a(n) ________.


  • Options
  • A. multimeter
  • B. current tracer
  • C. logic probe
  • D. oscilloscope

  • Correct Answer
  • current tracer 


  • Testing and Troubleshooting problems


    Search Results


    • 1. "Train" and "single" is the mode selection for a _______.

    • Options
    • A. multimeter
    • B. logic probe
    • C. current tracer
    • D. logic pulser
    • Discuss
    • 2. Erratic or unexplained digital circuit activity is often due to _________.

    • Options
    • A. a glitch
    • B. a random pulse
    • C. clock frequency changes
    • D. a change in slew rate
    • Discuss
    • 3. The control of digital circuits is usually achieved with _________.

    • Options
    • A. random pulses
    • B. clock signals
    • C. sophisticated gating
    • D. selected frequencies
    • Discuss
    • 4. The ideal test equipment to use for locating shorts in digital circuitry is the ________ and _______.

    • Options
    • A. logic probe, clip
    • B. logic pulser, logic probe
    • C. current tracer, logic pulser
    • D. current tracer, logic clip
    • Discuss
    • 5. An open collector output can ________ current, but it cannot ___________________.

    • Options
    • A. sink, source current
    • B. source, sink current
    • C. sink, source voltage
    • D. source, sink voltage
    • Discuss
    • 6. In order for a logic probe to operate, its red and black leads must first be connected to a ________.

    • Options
    • A. logic clip
    • B. HIGH or TRUE signal
    • C. power source
    • D. logic pulser
    • Discuss
    • 7. The use of a logic probe may be improved through the use of a(n) ________.

    • Options
    • A. logic clip
    • B. frequency counter
    • C. oscilloscope
    • D. current tracer
    • Discuss
    • 8. The results of internal IC failures will usually be noticed during the ______ phase of troubleshooting.

    • Options
    • A. diagnostic
    • B. isolation
    • C. repair
    • D. final test
    • Discuss
    • 9. A check of all power supply voltages should be made during the ________ method of troubleshooting.

    • Options
    • A. half-split
    • B. diagnosis
    • C. repair
    • D. final test
    • Discuss
    • 10. Multivibrators must be level-triggered.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment