Discussion
Home ‣ Electronics ‣ Testing and Troubleshooting Comments
- Question
"Train" and "single" is the mode selection for a _______.
Options- A. multimeter
- B. logic probe
- C. current tracer
- D. logic pulser
- Correct Answer
- logic pulser
- 1. Erratic or unexplained digital circuit activity is often due to _________.
Options- A. a glitch
- B. a random pulse
- C. clock frequency changes
- D. a change in slew rate Discuss
- 2. The control of digital circuits is usually achieved with _________.
Options- A. random pulses
- B. clock signals
- C. sophisticated gating
- D. selected frequencies Discuss
- 3. The ideal test equipment to use for locating shorts in digital circuitry is the ________ and _______.
Options- A. logic probe, clip
- B. logic pulser, logic probe
- C. current tracer, logic pulser
- D. current tracer, logic clip Discuss
- 4. An open collector output can ________ current, but it cannot ___________________.
Options- A. sink, source current
- B. source, sink current
- C. sink, source voltage
- D. source, sink voltage Discuss
- 5. Totem pole outputs _________ be connected __________ because ____________.
Options- A. can, in parallel, sometimes higher current is required
- B. cannot, together, if the outputs are in opposite states excessively high currents can damage one or both devices
- C. should, in series, certain applications may require higher output voltage
- D. can, together, together they can handle larger load currents and higher output voltages Discuss
- 6. The device that would best aid in open track detection is a(n) ________.
Options- A. multimeter
- B. current tracer
- C. logic probe
- D. oscilloscope Discuss
- 7. In order for a logic probe to operate, its red and black leads must first be connected to a ________.
Options- A. logic clip
- B. HIGH or TRUE signal
- C. power source
- D. logic pulser Discuss
- 8. The use of a logic probe may be improved through the use of a(n) ________.
Options- A. logic clip
- B. frequency counter
- C. oscilloscope
- D. current tracer Discuss
- 9. The results of internal IC failures will usually be noticed during the ______ phase of troubleshooting.
Options- A. diagnostic
- B. isolation
- C. repair
- D. final test Discuss
- 10. A check of all power supply voltages should be made during the ________ method of troubleshooting.
Options- A. half-split
- B. diagnosis
- C. repair
- D. final test Discuss
Testing and Troubleshooting problems
Search Results
Correct Answer: clock frequency changes
Correct Answer: clock signals
Correct Answer: current tracer, logic pulser
Correct Answer: sink, source current
Correct Answer: cannot, together, if the outputs are in opposite states excessively high currents can damage one or both devices
Correct Answer: current tracer
Correct Answer: power source
Correct Answer: logic clip
Correct Answer: diagnostic
Correct Answer: half-split
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.